[TenTec] Pound sign (#) on Jupiter screen

[Mike Bryce]

in the manual,

section 2 getting started

section 2.1 describes the # operation


Mike, WB8VGE
SunLight Energy Systems
The Heathkit Shop
http://www.theheathkitshop.com/
J e e p
o|||||||o 

> On Nov 20, 2018, at 7:32 PM, Winston <jones_winston at bellsouth.net> wrote:
> 
> I just now went back on air with the Jupiter. The # disappears when I start tuning, then appears about 5 seconds after tuning stops. Changing other settings didn’t seem to affect it, although I tried only a few.
> Again, no problems, just curious. I’ll see if I can find the manual reference.
> 
> 73, Winston K4CWQ
> 
> Sent from my iPhone
> 
>> On Nov 20, 2018, at 7:18 PM, Mike Bryce <prosolar at sssnet.com> wrote:
>> 
>> It’s in the manual, I can’t recall the actual page it’s on. but yup it means the radio’s current settings have been saved.
>> 
>> mike, wb8vge
>> “The trouble with quotes on the Internet is that you never  know if they are genuine”
>> 
>> —Abraham Lincoln
>> 
>>> On Nov 20, 2018, at 6:53 PM, Winston <jones_winston at bellsouth.net> wrote:
>>> 
>>> It’s not a whole bunch of #s, but a single one in the right corner. It doesn’t seem to cause any problems. I’m just curious. I could find no mention of it in the manual.
>>> I suspect now, as suggested above, it means the settings have been recorded into memory.
>>> 
>>> Winston K4CWQ
>>> 
>>> Sent from my iPhone
>> 
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec