[TenTec] Pegasus no Transmit

[MadScientist]

That sounds like the antenna relay.

However, those relays often failed anyway. I have a bunch of them from an Omni 5 junker.

Can you send me a photo of the one in your radio so i am certain.?

Gary

> On Oct 10, 2018, at 3:15 PM, Joe Word <n9vx.joe at gmail.com> wrote:
> 
> Gary,
> 
> It is the same on all bands.
> 
> I hear a tink sound when I unkey, but no sound when I key. Is the
> relay on the filter board,
> 
> yellow about 1 inch long?
> 
> 
> Joe  N9VX
> 
> -------------------------------------------------------------
> 
> Is it the same on all  bands?
> 
> When going to TX, do you hear the antenna relay clicking? (Listen very closely
> as this radio’s really is very quiet.)
> 
> I have seen the coils go open on the reed relays TT used for antenna switching.
> 
> Gary
> 
> W0DVN
> 
> 
> On Wed, Oct 10, 2018 at 2:41 PM Joe Word <n9vx.joe at gmail.com> wrote:
> 
>> My Pegasus has no transmit output.
>>> Receive works fine.
>>> No output on any band on CW or SSB.
>>> Red TX light comes on.
>>> It does draw power supply current changing with power setting.
>>> SSB TX sounds good in monitor.
>>> Has LDG tuner, no change if bypassed.
>>> Running Ten-Tec software.
>>> I have unplugged, cleaned and reconnect connectors,
>>> I see no physical component damage.
>> 
>> Any thoughts?
>> 
>> Joe  N9VX
>> 
>> 
>> --
>> I'd rather *talk* than* type*.
>> 
> 
> 
> -- 
> I'd rather *talk* than* type*.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec