[TenTec] Discussion of Ten-Tec Equipment

[Bwana Bob]

Snowy:

Check here on the Ten Tec wiki for my Paragon PLL  troubleshooting write 
up: http://tentecwiki.eqth.net/doku.php?id=585pll

73,

Bob WB2VUF

On 9/20/2018 1:18 PM, ROLAND HOWELL via TenTec wrote:
> Hi MarkUnfortunately that is not an option open to me as it was purchased as spares or repair, however I have now got it working, not 100% more like 80%, now have audio and a message saying that PLL is out of lock, on all frequencies not just 1 band, I have had all 3 boards out and resoldered everything, found no end of dry joints and some that had never seen a splash of solder, but still got the same message.thanks for your inputSnowy G0HZE
>
>      On Thursday, 20 September 2018, 17:07, mark kenward via TenTec <tentec at contesting.com> wrote:
>   
>
>   The Paragon is a lot different from PII.
> I would go for my money back unless it was a give away.
> Old Paragons were known for bad solder joints all over.
> PII is more line Omni 6. With general coverage and ssbAM included, plus FM.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>     
>
> |  | Virus-free. www.avast.com  |
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>



---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus