[TenTec] Discussion of Ten-Tec Equipment

[Greg S]

Good luck, Snowy....I soldered on one for a while for a dear elderly friend, with no luck. A scientific approach would have probably proved more useful, but he told me to keep it for parts. 
73- Greg KC8HXO 

Sent from my Linux device

> On Sep 20, 2018, at 13:18, ROLAND HOWELL via TenTec <tentec at contesting.com> wrote:
> 
> Hi MarkUnfortunately that is not an option open to me as it was purchased as spares or repair, however I have now got it working, not 100% more like 80%, now have audio and a message saying that PLL is out of lock, on all frequencies not just 1 band, I have had all 3 boards out and resoldered everything, found no end of dry joints and some that had never seen a splash of solder, but still got the same message.thanks for your inputSnowy G0HZE 
> 
>    On Thursday, 20 September 2018, 17:07, mark kenward via TenTec <tentec at contesting.com> wrote:
> 
> 
> The Paragon is a lot different from PII.
> I would go for my money back unless it was a give away.
> Old Paragons were known for bad solder joints all over.
> PII is more line Omni 6. With general coverage and ssbAM included, plus FM.
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
> 
> 
> |  | Virus-free. www.avast.com  |
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec