[TenTec] looking for the remote tuning pod that works with the jupiter

[wt4t at reagan.com]

Alex
 thanks for the info. are there any special specs on the encoder? and the wiring layout for the 232 plug to the radio.
thanks
dale
wt4t
-----Original Message-----
From: "Radio AI2Q" <ai2q at roadrunner.com>
Sent: Monday, August 26, 2019 7:02am
To: tentec at contesting.com
Subject: Re: [TenTec] looking for the remote tuning pod that works with the jupiter



Dale, you can make one using an optical encoder. Mine is mounted in a 
small box that sits on the operating table. It communicates with my 
Omni-V via a cable and the RS-232 connector on the back of the transceiver.

Vy 73, AI2Q, Alex



On 8/25/2019 12:38 PM, dale via TenTec wrote:
> HI
> Looking for the above ten tec tuning pod that the jupiter and other ten tec radios used. It was like the flex control used on flex radios.
> thanks for looking
> 73
> dale
> wt4t
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


---
This email has been checked for viruses by AVG.
https://www.avg.com

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec