[TenTec] looking for the remote tuning pod that works with the jupiter

[Radio AI2Q]

It's been years since I looked at it, Dale. I'll try and find my notes.

Vy 73, AI2Q, Alex


On 8/26/2019 9:47 AM, dale via TenTec wrote:
> Alex
>   thanks for the info. are there any special specs on the encoder? and the wiring layout for the 232 plug to the radio.
> thanks
> dale
> wt4t
> -----Original Message-----
> From: "Radio AI2Q" <ai2q at roadrunner.com>
> Sent: Monday, August 26, 2019 7:02am
> To: tentec at contesting.com
> Subject: Re: [TenTec] looking for the remote tuning pod that works with the jupiter
>
>
>
> Dale, you can make one using an optical encoder. Mine is mounted in a
> small box that sits on the operating table. It communicates with my
> Omni-V via a cable and the RS-232 connector on the back of the transceiver.
>
> Vy 73, AI2Q, Alex
>
>
>
> On 8/25/2019 12:38 PM, dale via TenTec wrote:
>> HI
>> Looking for the above ten tec tuning pod that the jupiter and other ten tec radios used. It was like the flex control used on flex radios.
>> thanks for looking
>> 73
>> dale
>> wt4t
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> ---
> This email has been checked for viruses by AVG.
> https://www.avg.com
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec