[TenTec] Audio popping on end of CW note in monitor

Howard Smith jhsmith1024 at gmail.com
Mon Jul 29 14:23:08 EDT 2019

Hi Petr,

If you follow the rest of the link that you provided, it did give a 
solution to the problem.  You need to set the CW QSK Delay in the CW 
menu to a value of 2%.  This causes the rx to be delayed very slightly, 
and the pop is then gone.  The value of 2 is very small and will not 
cause any problems.

There were no Orion II (566) releases after V3.033xe.


Howard, WA9AXQ

More information about the TenTec mailing list