[TenTec] ALC pot for Corsair II

[AA2PM, Paul]

Good afternoon, Karl:

You may want to try Greenbrook Electronics in North Plainfield, NJ, or Mauser, or even Amazon...

73,

AA2PM, Paul Mondok

Before printing this document, please think about the environment.

-----Original Message-----
From: TenTec [mailto:tentec-bounces+aa2pm=earthlink.net at contesting.com] On Behalf Of Karl Heimbach
Sent: Wednesday, December 23, 2020 11:31 AM
To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
Subject: [TenTec] ALC pot for Corsair II

All,

I have a Corsair II that I picked up at a hamfest that needs a bit of TLC.  Somewhere along the line, the ALC pot was cross-threaded when it was installed in the front panel.

The pot works for about 40% of its rotation, and then shorts. The schematic indicates that it is a 10K pot.  Problem is, that I have not been able to find a 10K pot with a footprint that will fit.

The original pots are about 50% of the size of commonly found potentiometers and also have a small diameter shaft.

Does anyone have an idea of where I could find a smaller pot that will fit?

Thank you,

Karl - W5QJ

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec