[TenTec] Omni V narrow (model 218) 9 MHz crystal ladder filter option.

[Doug Gomez]

 Thanks Bob,
I did remove the board in question and cleaned the pins, but I'll revisit and carefully clean other pins, as well.
73, Doug KC6RCM
    On Monday, January 27, 2020, 04:28:57 PM PST, Bob McGraw K4TAX <rmcgraw at blomand.net> wrote:  
 
 Open the radio, pull the filter and clean the pins and then put the 
filter back in place.   Also do the same with the gain jumper.   Sounds 
as though the radio would be served better with a good connector 
cleaning and exercising.

73

Bob, K4TAX


On 1/27/2020 5:58 PM, Doug Gomez via TenTec wrote:
> I installed the narrow filter board when I purchased the rig new in 1990.  Recently, I've noticed adding this narrow filter mutes the receive signal almost completely when any filter selection (2.4, 1.8, .50 or .25) is selected  It did not do this in the past.  The jumper is in the correct (pins 2&3) location for this filter, as well.
> Anyone having experience with this board and which component(s) went awry would be greatly appreciated.
> Thank you, Doug, KC6RCM
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec