[TenTec] Omni VI+ freq display

[Bob McGraw K4TAX]

I would first check and adjust the BFO oscillators using the procedure as described in the manual.  Then check each band to determine if it is one band or all bands and the amount of error.  
This has to be done with a known accurate frequency counter.   

If all bands then adjust the Master Oscillator to correct the error.   Typically +/- 50 Hz is about as good as one can expect.  

Bob, K4TAX


Sent from my iPhone

> On Jul 31, 2020, at 7:25 AM, Paul DeWitte <k9ot at yousq.net> wrote:
> 
> I have an Omni VI+ that displays the incorrect freq readout.
> My owners manual does not give any indication on how to correct this.
> Can someone give me the correct way to correct this?
> An example is if you wanted to be on 7200, you would have to tune to
> 7200.19 to be on the correct freq.
> Thanks!
> 73 Paul K9OT
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>