[TenTec] TU...Re: Orion II Master Reset upon power-on

[Bob, W3IDT]

THANK YOU

.......
. Robert F. Teitel, W3IDT
.
. w3idt at comcast.net
. w3idt at arrl.net
........

On 12/6/2021 7:18 PM, w4ag at mindspring.com wrote:
> One of the batteries I replaced in my O2 lasted only a few weeks. I suspect
> that it had been on a vendor's shelf for too long. I was having the same
> symptoms you are reporting. A new battery from a different vendor fixed the
> problem.
> 
> Good luck,
> Stan, W4AG
> 
> 
> -----Original Message-----
> From: TenTec <tentec-bounces+w4ag=mindspring.com at contesting.com> On Behalf
> Of Bob, W3IDT
> Sent: Monday, December 6, 2021 5:33 PM
> To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
> Subject: [TenTec] Orion II Master Reset upon power-on
> 
> All,
> 
> Some weeks ago, I sent a note regarding several problems I'm having with my
> Orion II. Perhaps I can ask this time about one specific issue:
> 
> Whenever I power-on my O2, it does a Master Reset.
> (And, of course, loses all USER1 and USER2 settings.)
> 
> The caps on the A9 board were replaced a couple of years ago.
> I replaced both batteries a few weeks ago.
> I've tried both firmware 3.033xa and 3.033xe.
> And did the necessary Master Resets and RAM Clears.
> I've removed all external interfaces (MicroKeyer).
> 
> Still happens.
> 
> Anyone have any clue?
> 
> (I'm thinking that if I get this issue solved, maybe the other issues go
> away too.)
> 
> Thanks for any suggestions.
> 
> Bob, w3idt
> --
> .......
> . Robert F. Teitel, W3IDT
> .
> . w3idt at comcast.net
> . w3idt at arrl.net
> ........
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>