Topband: Re: Pennant antenna

[B.A. Clark]

Hello Henrik ,

The attached  file is modeling for my Flag antenna. To see the front to back
correctly is must be run from the NEC WIRES part of the AO antenna program.

The wires to the remote termination would cause errors in the Pennant antenna.
If light fibers could be devised instead of wires to the remote termination it
would work OK.

73
Bruce-K1FZ

Point Fed Pennant 1.830 MHZ @ K1FZ
over ground
1.830 MHZ
3 copper wires, feet
bot = 6      	    ; bottom
top = 14            ; top length
x1 = 29             ; x of point
z1 = bot + top	    ; z of top
z2 = top/2 + bot    ; z of point
x = x1              ; x of point
1   x   0   z2   0  0  z1  #14
1   0   0   z1   0  0  bot #14
1   0   0   bot  x  0  z2  #14
1 source
wire 1, end1 
1 load
Wire 2, center 860 ohms
 




--
FAQ on WWW:               http://www.contesting.com/FAQ/topband
Submissions:              topband@contesting.com
Administrative requests:  topband-REQUEST@contesting.com
Problems:                 owner-topband@contesting.com