Topband: Grounded Tower

Joe Subich, W4TV w4tv at subich.com
Fri Aug 4 16:03:12 EDT 2006


Jim Jarvis writes: 

> I disagree.  There is data to the contrary...that is, that a 
> few elevated radials work better than an insufficient on/in 
> ground system.  I am sure this depends on the conductivity of 
> the earth involved, to some degree.

Jim, you've opened a real can of worms.  

You can't say there is "data" to the contrary ... there may be 
legend, anecdote or even model studies but there are no validly 
conducted field strength studies that show elevated radials to 
outperform a reasonable (16 - 32 radials) in ground system when 
the length of the in ground radials are "sufficient" (e.g., 
separation of .03 wave at the tips).  Quite the opposite in 
those cases where before and after measurements were taken where 
elevated radials were replaced by a reasonable in ground system 
in broadcast service, the in ground system outperformed (and were 
more stable) the elevated radials that were replaced.   

73, 

   ... Joe, W4TV 
 


> -----Original Message-----
> From: topband-bounces at contesting.com 
> [mailto:topband-bounces at contesting.com] On Behalf Of Jim Jarvis
> Sent: Friday, August 04, 2006 12:27 PM
> To: topband at contesting.com
> Subject: Re: Topband: Grounded Tower
> 
> 
> 
> Quoth N9RF:
> 
> "I would opt for a known performer -- the shunt-fed tower with in/on
> ground radials.  Regardless of claims that 4 elevetaed radials
> outperforms many on/in ground radials, the opposite has been proven by
> field strength measurements."
> 
> I disagree.  There is data to the contrary...that is, that a 
> few elevated
> radials work better than an insufficient on/in ground system. 
>  I am sure
> this
> depends on the conductivity of the earth involved, to some degree.
> 
> At the same time, I would favor in-ground on the basis of 
> aesthetics.  If
> you can get in 12-24 radials, even of varying lengths, you'll 
> be better off.
> If not, then you should consider flying 4 radials @ 10' or so up.
> 
> On the topic of eliminating coupling between the tower and a 
> k9ay loop which
> is only .6 lambda away?  Only way to decouple is to ACTIVELY 
> do so...that
> is, to
> use a relay to switch in (or out) tuning components for the 
> tower which
> would
> result in it being resonant well away from 1.830.
> 
> n2ea
> jimjarvis at ieee.org



More information about the Topband mailing list