Topband: Radials over a stone wall

[ZR]

What about pushing them thru holes in the wall? I do that with the radials 
for a pair of 2 wire Beverages that terminate at trees right at the wall 
which has been there since at least the early 1800's.

If you have to push 2-3 thru the same hole it shouldnt matter.

Carl
KM1H



----- Original Message ----- 
From: "N2TK, Tony" <tony.kaz at verizon.net>
To: "'topband'" <topband at contesting.com>
Sent: Friday, August 10, 2012 11:17 AM
Subject: Topband: Radials over a stone wall


>I shunt feed my tower for topband. I use variable vacuum caps and a vacuum
> relay at the base to switch between the low end and the high end of the
> band. It seems to work okay. I have 100' buried radials spaced 10' at the
> ends from o degrees going clockwise through about 220 degrees. I have a 4'
> high stone wall that runs about 20/200 degrees that is about 35' at its
> closest point to the tower. So the radials are progressively shorter on 
> the
> West side of the tower.
>
>
>
> I am making an assumption that going up over the wall will distort any
> benefits of extending the radials on the West side? Is that a true
> assumption.
>
> I can't really have the radials go from the tower base up at an angle to
> clear the stone wall and continue on. If I am to extend them the radials
> would have to go on the ground to the wall then up and over and back down 
> to
> the ground.
>
>
>
> 73,
>
> N2TK, Tony
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2437/5191 - Release Date: 08/10/12
>