Topband: RESOLVED: Help needed with RTR-1A

Mark Lunday mlunday at nc.rr.com
Sat Sep 24 00:23:58 EDT 2016


Thanks to the 15 or so hams who contacted me offline to assist with this
issue.  The resolution:

 

1.       The RTR-1A units are working fine (no surprise there)

2.       It is NOT operator error (BIG surprise there)

 

After some more research on different message boards, and a great discussion
with Rod at DX Engineering, I learned that the TS480SAT 8-pin mini DIN
connector ground does NOT connect to chasis ground!  Therefore, the RTR-1A
won't function as I was trying to set it up.

 

Thanks to Dan, YO3IRM, I was able to get the unit hooked up and working
perfectly.   

 

For any other hams using a TS480SAT, see the attached GIF for how this was
resolved.

 

Mark Lunday, WD4ELG

Greensboro, NC  FM06be

wd4elg at arrl.net

http://wd4elg.blogspot.com

 

From: Mark Lunday [mailto:mlunday at nc.rr.com] 
Sent: Sunday, September 11, 2016 12:29 AM
To: 'topband at contesting.com'
Subject: Help needed with RTR-1A

 

am trying to set this up for a separate receive antenna.  I had it working
with my Flex 3000 before I sold that rig.  Now I am trying to use it with my
TS-480SAT.

I actually have TWO identical units.  Both are exhibiting the same behavior:
without even connecting the RCA ground plug, I cannot get the units to
switch between receive antenna and transmit antenna using the toggle on the
front of the unit.  (I think that's how I accidentally ordered the second
unit 6 years ago, I thought the first one had an issue after moving my
shack, but somehow I hooked everything up and it worked fine).

I can receive RF from the transmit antenna jack through the RTR-1A to the
TS480.  This is the default behavior with power off.  With the power on, I
see the same behavior for both units, and regardless of the toggle setting
on the right hand side (RX ANT or MAIN ON).

Mark Lunday, WD4ELG

Greensboro, NC  FM06be

wd4elg at arrl.net

http://wd4elg.blogspot.com



More information about the Topband mailing list