Topband: YCCC 9 circle/5 square

[W0MU Mike Fatchett]

Did DXE not sell enough of these to continue?  It appears the PI4CC  
folks are reworking the controller as the page says QRX.

On 2/20/2019 2:37 PM, Mike VE3CKO wrote:
> There seems to be no controller board available, just the pre-amp, 
> switching and phasing boards. Did I miss something?
>
>    RX-amps, you will get 10 pieces for 20 euro.
>    Switch-board you will get 5 pieces for 20 euro.
>    Phase board you will get 5 pieces for 20 euro.
>
>    https://www.pi4cc.nl/tech-info/rx-array/iwantone/
>
> If your putting an order together, count me to split up.
>
> 73, Mike Kovacich - VE3CKO
>
> On 2/19/2019 2:03 PM, David Olean wrote:
>> Mike,
>>
>> You can get boards from PI4CC HF club in the Netherlands. The problem 
>> is that you get more boards than one person needs. The boards are 
>> coming from China. I think it is a shipping situation. You can get 10 
>> preamp boards and then five of the switching/phasing boards and five 
>> of the controller board.  I am looking to pool an order for a nine 
>> circle array, so I need ten preamps (one spare) and a single switcher 
>> and a single controller. I don't want or need five!  Even splitting 
>> it two ways is a good deal for the cost.  (20 EU for five ) Check out 
>> the page.
>>
>> https://www.pi4cc.nl/tech-info/rx-array/controller/
>>
>>
>> Dave K1WHS
>>
>> On 2/19/2019 5:40 PM, Mike VE3CKO wrote:
>>> I see the YCCC 9 circle/5 square kits are no longer available from 
>>> DX Engineering. Is there somewhere to buy the kits or at least some 
>>> key parts like the PCBs?
>>>
>>
>>
> _________________
> Searchable Archives: http://www.contesting.com/_topband - Topband 
> Reflector