[TowerTalk] Rohn 45 Check Jig

[Gerald Smith]

After observing the terrible quality of the Rohn 45 sections I received,
I ask my handyman/carpenter to build a jig to check the alignment of the
sections and the alignment of the holes. He built a jig which is on
plywood with dowels attached to each side. One side for the skinny tube
end and one side for the fat, sleeved end. It proved to be an invaluable
tool in determaning which sections were bad. It cost me $60.

If anyone else is in the same situation, Email mail me and I will pass
along my handyman's name and number.

Gerry, W6TER

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm