[TowerTalk] Bolt Pattern for G800S & Tailtwister Rotators

[Robin E. Midgett]

Hello TT,
I'm in need of the bolt patterns for the G800S & Tailtwister rotators. I'm 
fabricating rotator shelves for these rotators for someone else & I would 
like to know where to bore the holes, relative to each other, on the plate. 
I know the Ham II/IV series is on 3" centers, is the Tailtwister the same? 
I do not have either of these rotators. Any useful information is very much 
appreciated.
73,
Robin E. Midgett KB4IDC EM66se
rmidgett@bellsouth.net
1/2 of the Award Winning NT4L Rover Team
http://kq4tv.aprs.net/vhf/vhf.html


--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm