[TowerTalk] Plumbing a tower using a plumb bob
Bill Heinzinger
w9ol@dataflo.net
Mon, 18 Oct 1999 20:57:18 -0500
Actually a plumb bob is the most accurate.
The Greeks and Romans didn't have transits. HI
what you do:
If the tower has a pointed top section:
A tennis ball with a hole in it. Place the string through the hold and lover
bob down the mast tube letting the ball sit in the hole.
If the tower has a flat top section and rotor plate, just get a bigger ball.
I've used this technique many times. cheap and fast
Only problem could be a windy day. Then you need a heavier bob.
Elevator installers used to use a BIG steel bob and piano wire to align the
elevator rails.
----- Original Message -----
From: Tom H <biskit@snip.net>
To: <towertalk@contesting.com>
Sent: Monday, October 18, 1999 8:50 PM
Subject: [TowerTalk] Plumbing a tower using a plumb bob
>
> Hey 'tawkers,
>
> I'm trying to figure a way to find the center of a triangular tower so I
can
> drop a plumb line from near the top, down to the bottom. This seems to me
> like a good way to find true vertical other than using a transit. What
I'd
> like to do is to criss-cross a string from one tube to the other to form a
> center cross hair of sorts, one at the top, and one at the bottom, and
hang
> a plumb bob from the top cross hair. But without an opposing tube, this
is
> pretty hard to do. There's gotta be a better way to do this than how I'm
> figuring. Any suggestions?
>
> Thanks,
> Tom K3GM
> FM29
>
>
>
> --
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm