[TowerTalk] rotor plate bolt hole patterns

[Joe L Blackwell]

Hi Val
Good news, I guess, and finagling with the T2X to make it fit seems okay
to me.  But when I called the factory about the T2X the did not recommend
it.
de Joe aa4nn

ValErwin@aol.com writes:
> Guys:
> 
> I also have a US Tower but different model.  I also found that the T2X
would 
> not fit -- if you tried to pass it through the zig-zags.  But, I found
that I 
> could use the T2X by  shoving the T2X  in from the very bottom and on
up the 
> inside of  the tower, when it was tilted  over.  Then, when you get  to
the 
> bottom of the rotor shelf, remove the shelf, and continue on past with
the 
> T2X. Then, replace the shelf and  drop the T2X down onto the shelf.  
> When my T2X rotates, the "bolt ears" of the T2X pass within 0.25 inches
of 
> the  zig-zags.
> 
> GL
> 

--
FAQ on WWW:               http://www.contesting.com/towertalkfaq.html
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm