[TowerTalk] Rotor-EZ rotor control

[K7LXC@aol.com]

In a message dated 06/08/2000 4:25:07 PM Pacific Daylight Time, w1vxv@gwi.net 
writes:

> About a week ago I read a posting here about the new "hands free rotor
>  control plus RS232" for the Ham-M and Tailtwister rotors.  I followed
>  the reading of the review by visiting http://www.idiompress.com/ to get
>  the scoop from the kit seller.  I immediately ordered the kit for my
>  rotor, and didn't realize until tonight that mine is a Ham-IV and not a
>  Ham-M.  (never assume anything  <grin> )

     Wait a minute. The Ham IV and TailTwister both use the same 8-wire 
control box. I'm not sure but I think the Ham-M does too. 

     The kit does fit your Ham IV. What makes you think it doesn't? They 
haven't changed these control boxes (or rotators) since the 60's so the kit 
should fit just about everything.

Cheers,   Steve   K7LXC
Tower Tech

--
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com