[TowerTalk] Yaesu Rotor Repair?
Joe L Blackwell
aa4nn@juno.com
Wed, 8 Mar 2000 03:46:34 -0500
If you open your Yaesu rotator, be prepared for a lot of ball bearings to
fall out.
de Joe, aa4nn
"Dave D'Epagnier" <DDEpagnier@compuserve.com> writes:
>
> Well, I got my cracked rotor mast clamp replaced for my G-600x. Yaesu
had
> it in stock. It's interesting that they now say it's important to pin
the
> mast. They include a long bolt and drilling instructions for it. My old
> clamp didn't even have a hole for pinning.
>
> Anyhow, in one of my brighter moments, I attached the rotor wires up
wrong
> and applied about 900mW to the position sensing potentiometer in the
rotor
> and smoked it. How can I get this fixed? Is it easy for me to fix this
or
> is opening a rotor liken to tearing into an automobile transmission?
> Has anybody on the list ever replaced one of these? Should I do it
myself or
> send it off to Norm's etc?
>
> tnx,
>
> Dave
> K0QE
>
> --
> FAQ on WWW: http://www.contesting.com/towertalkfaq.html
> Submissions: towertalk@contesting.com
> Administrative requests: towertalk-REQUEST@contesting.com
> Problems: owner-towertalk@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
73, de Joe aa4nn
Ten-Tec only, CW only.
eeetet ee
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm