[TowerTalk] LMR-600 for rotor loop??

[Rick]

Is it possible to successfully use LMR-600 (not LMR-600 ultra flex) for
rotor loop transition from hardline? I see that the minimum bending
radius is spec'd at 1.5" so I propose "looping" several feet of LMR-600
around the top of my new tower to use as the transition from hardline to
the antenna feed point.  If this is not practical, what is the lowest
loss feed line acceptable for rotor loops?   Thanks  Rick wa5rt

--
FAQ on WWW:               http://www.contesting.com/FAQ/towertalk
Submissions:              towertalk@contesting.com
Administrative requests:  towertalk-REQUEST@contesting.com
Problems:                 owner-towertalk@contesting.com