[TowerTalk] rotator mast clamp
K7LXC@aol.com
K7LXC@aol.com
Sun, 24 Sep 2000 18:07:57 EDT
In a message dated 9/24/00 2:40:27 PM Pacific Daylight Time,
w7zr@redrivernet.com writes:
> i have a rotating tower that has a 1 1/2" shaft that should couple to a
> rotator.
> Problem is my T2X or my Create rotator mast clamps won't go down to 1 1/2".
> Looking for ideas.
Have you got room for an adapter pipe - 1.5" ID to 2" OD? A piece of
1-1/2" water pipe would work. The trick is to pin the two together.
I have never found a satisfactory way to shim masts to rotators.
What about just pinning the 1.5" right to the mast clamp? The T2X already
has a hole in the rotator upper clamp and you can just let the fit be sloppy.
If you get some huge forces on the antenna/tower, the bolt will act like a
fuse/shear pin anyway so you can't get into too much trouble.
Sounds like you're getting ready for SS for the first time in years.
Cheers, Steve K7LXC
Tower Tech
--
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com