[Towertalk] Nylon guys
WA2BPE
wa2bpe@exotrope.net
Thu, 11 Apr 2002 15:10:18 -0400
The material by "Synthetic Textiles" is a white/cream colored Dacron with the
outer weave dyed (permanently) black (just looked at a reel of it). I haven't
used it as guys, but have used it to secure cables to a steel messenger. I have
seen no (visible) degradation in over 20 years exposure to sunlight and it
remains flexible. BTW, one of the best ways to terminate/cut the material is to
fuse the outer weave (a short (1") section) with a torch or heat gun (hold it
under light tension and rotate it while heating), clip it with a wire cutters
then complete the fusing/sealing of the end. Be careful on heating; too much
will result in smoky flames! The nice thing abt this product is that it is very
flexible/easy to work with. It does stretch, however, and needs to be
pre-stretched - M^2 uses this for the truss guys on some of their bigger (6m for
sure) beams.
73, Tom - WA2BPE
K7LXC@aol.com wrote:
> In a message dated 4/11/02 11:16:09 AM Pacific Daylight Time,
> RedHaines@centurytel.net writes:
>
> > Nylon deteriorates when exposed to UV. If you use it for guys or
> > anything else outdoors, plan to inspect it often and replace it
> > occasionally. I'm not sure how to determine that its strength is not
> > reduced too much. I suppose if you start with more than sufficient
> > strength, you can tolerate more deterioration.
> >
> > I recommend using materials made for exterior applications. I haven't
> > research which ones are best.
>
> The best outdoor rope for ham-type uses is the UV resistant stuff made by
> Synthetic Textiles. There are a bunch of ham dealers including DavisRF.
>
> I don't know of any other rope that'll stand the UV.
>
> Cheers,
> Steve K7LXC
> TOWER TECH
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk