[Towertalk] rotator tune-up checklist

[Jim White]

HA HA HA

Been there done that.....Dad used to have a special shallow cardboard box he
would use when he seperated the housing halves on the Ham-M....otherwise
know as....

"Their Off"

boing boing boing - note this is also a good reason to use somewhat
excessive quantities of grease upon reinstalling them - helps keep them in
their place while you jiggle the housing halves....I often wonder how many
of thsoe ball bearings the new home owner found when in the basement when my
folks moved!

K4OJ

----- Original Message -----
From: "Fred Hopengarten" <k1vr@juno.com>
To: <w5lew@bellsouth.net>; <towertalk@contesting.com>
Sent: Wednesday, May 22, 2002 11:31 AM
Subject: Re: [Towertalk] rotator tune-up checklist


>
> On Tue, 21 May 2002 23:16:13 -0500 "Lew King" <w5lew@bellsouth.net>
> writes:
>
> > I want to checkout my Ham IV Rotator I got with my free tower - lube
> > it, check gears, components, etc, get it ready to go. Is there a
> checklist somewhere I can use?
> >
> > I know about C.A.T.S. and Norm's trade-in deal, but I'd like to do
> > it myself, if possible (please say it's cheaper that way :)
> >
> > Lew W5LEW
>
> K1VR:  As you approach this project, remember that there are only two
> kinds of people. Those who have opened up a Ham IV and seen the
> ball-bearings bounce and roll all over the floor, and those who have
> never opened up a Ham IV.
>
> Fred Hopengarten K1VR                       hopengarten@post.harvard.edu
> Six Willarch Road * Lincoln, MA 01773-5105
> 781/259-0088 *eFax 419/858-2421
>
> ________________________________________________________________
> GET INTERNET ACCESS FROM JUNO!
> Juno offers FREE or PREMIUM Internet access for less!
> Join Juno today!  For your FREE software, visit:
> http://dl.www.juno.com/get/web/.
> _______________________________________________
> Towertalk mailing list
> Towertalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk