[TowerTalk] Rohn 25G Harware

[Mark Beckwith]

Right, but they're not stainless. But they ARE original equipment and are
the manufacturers spec.

Mark, N5OT

----- Original Message ----- 
From: "Dale Martin" <kg5u at hal-pc.org>
To: <towertalk at contesting.com>
Sent: Sunday, October 19, 2003 2:51 PM
Subject: RE: [TowerTalk] Rohn 25G Harware


>
> >
> Ed,
> I don't know the exact specs on the bolts, but here's some info on where
you
> can buy them by the set:
>
> http://lists.contesting.com/archives//html/Towertalk/1998-09/msg00099.html
>
> Hope this helps.
>
>
> 73,
> dale, kg5u
>
> >  Hello
> >
> >  I recently bought a used Rohn 25G tower (70 ft).  It had been taken
down
> > and non of the hardware was included - does anyone know the proper bolt,
> > nut, lockwasher specification (size, etc.).  I intend to use
> > stainless steel
> > hardware - is there a spec (hardness rating, etc.) for stainless?
> >
> > Any help is appreciated.
> >
> > Regards
> >
> >  Ed Laughery
> >  AD5JV
> >  225-686-1450  Office
> >  225-229-8667  Cell
> >
> >
>
> _______________________________________________
>
> See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>