[TowerTalk] Dazed and Confused in downtown Goodrich, MI

[Mike Switzer]

Thanks Don

 

That is what I have tried to do.  My rotor plate does not fit “just above
the horizontal Z brace.  It will not physically tip into place except about
½ the way between two horizontal braces.  I have not resorted to the large
hammer approach yet however.   My objection is that there is no support for
the plate to sit on.  I have fashioned a brace for the plate to sit on out
of some aluminum angle stock.  I am using a thrust bearing so there will not
be any weight on the plate except the rotor (T2x).  Maybe I am worrying
about something I don’t need to worry about.  I need to measure the plate,
something I still have not done despite suggestions from you all.  So lets
see where is my measuring device????

 

mike

 

K8ZE

k8ze at charter.net