[TowerTalk] Cadweld, Ultraweld, etc

[Joe - KC2TN]

I used ductseal on the bottom of my forms to prevent runout. It works great.
It does get a little warm after the burn but is reusable on the next weld. I
did 32 welds without a problem. My neighbor, an electrician, gave me the
tip.

Joe - KC2TN
"If you're sure of everything,
        and it still doesn't work,
           one of the things you're sure of is wrong!"


-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com]On Behalf Of Thomas Miller
Sent: Saturday, September 27, 2003 11:06 AM
To: kb9cry at comcast.net; Jerry Keller
Cc: (Reflector) TowerTalk
Subject: Re: [TowerTalk] Cadweld, Ultraweld, etc


I have heard the use of duckseal to work on old worn out forms but I am not
sure how safe this is.
Tom


----- Original Message -----
From: <kb9cry at comcast.net>
To: "Jerry Keller" <k3bz at arrl.net>
Cc: "(Reflector) TowerTalk" <towertalk at contesting.com>
Sent: Wednesday, September 24, 2003 3:46 PM
Subject: Re: [TowerTalk] Cadweld, Ultraweld, etc
k my memory.  You also don't
> need to buy every different mold for all the applications you listed.  For
> example, you can use the one in and one out for a single wire terminating
at
> the rod by simply stuffing a small stub of wire into the other opening and
then
> use the weld.  You can also do the same for the two in and two out by
again
> sticking a short stub of wire into the unused openings.  You want to fill
these
> up with something so the molten metal does not leak out.  QSL?

_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk