[TowerTalk] Rotor plates

[Keith Dutson]

I have a Rohn catalog.  There is a note by the AS25G that indicates the hole
pattern may be modified to accommodate various rotors and other appliances
(e.g. TB3-TB4).  I read this as "user drilled."

Keith NM5G

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of W3YY
Sent: Thursday, November 04, 2004 2:35 PM
To: TowerTalk List
Subject: Re: [TowerTalk] Rotor plates

Greg -

That may explain my situation.  I have an AS-25G with a TB-3 installed and
the holes don't look post-factory, but I can't remember drilling them.  And,
as you know the holes are pretty big and would require a special bit.  Who
knows.  In any case, if you've got an AS-25G with TB-3 holes, great.  If not
drill some new ones and use it for the TB-3.  It makes a great thrust
bearing plate either way.

73, Bob - W3YY

----- Original Message -----
From: "Greg Gobleman" <k9zm at frontiernet.net>
To: "W3YY" <w3yy at cox.net>
Sent: Thursday, November 04, 2004 11:32 AM
Subject: Re: [TowerTalk] Rotor plates


> There has to be more than one 25 series plate available and some are
> drilled for a TB3.  I have one with a TB3 mounted and I didn't drill the
> holes to mount it.
>
> 73
> Greg K9ZM
>
>
> >
> >
>
>


_______________________________________________

See: http://www.mscomputer.com  for "Self Supporting Towers", "Wireless
Weather Stations", and lot's more.  Call Toll Free, 1-800-333-9041 with any
questions and ask for Sherman, W2FLA.

_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk