[TowerTalk] superflex for rotor loop?

[Peter Voelpel]

I use standard 1/2" hardline around the rotators for more then 20 years
without any problem or cable break.
The cables are formed into a one layer spring like that in a mechanical
clock.
My rotators turn 540°

73
Peter

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Hector Garcia XE2K
Sent: Sonntag, 30. April 2006 21:35
To: radio_k4rv at peoplepc.com; towertalk at contesting.com
Subject: Re: [TowerTalk] superflex for rotor loop?

i will not use  that Hardline for rotor loop, is just
superflex because can be reduced the diameter smaller
than the conventional hardline, in continous bending
will break sooner or more than sooner.

use the 9913f or LMR 

--- radio_k4rv at peoplepc.com wrote:

> Is Andrew 1/2 inch superflex continuously flexible
> enough to be suitable for 
> use as a rotor loop?
> 
> Thanks,
> Tom K4RV 
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
>
http://lists.contesting.com/mailman/listinfo/towertalk
> 


Hector Garcia XE2K / XF1K
Mexicali B.C  DM22fp

http://www.dxxe.org
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk