[TowerTalk] Dis-assembly instructions for a HAM series rotor

[Clint Talmadge]

I have a HAM 2 that I would like to take apart to insure it is OK to install in a tower.  It worked when I took it down and works now on the bench but I would feel better about the installation if I  **KNEW**  it was OK inside.  I would also like to swap out the terminal strip with a new one with stainless hardware.  I have Googled it and found lots of references to the electrical elements but no instructions on the mechanical aspect of the effort.  

Does a step-by-step instruction set exist and if so does anyone have one I might borrow or if it is commercially available where might I purchase same?

Clint - W5CPT