[TowerTalk] UFER Towerbase for 220ft "wifi" tower
Beat.Meier at gmx.ch
Wed Jun 21 15:06:11 EDT 2006
I'm looking for an "easy" method to calculate more or less a tower base for my tower.
The tower is NOT self supporting.
Height: 66m (220ft)
Material: Painted steel, not galvanized.
What is mounted are only "small" parabolid grids (1mx0.7m) and omni antennas.
Every 6m there are the cables. From the base to half of the tower the cables go to 25m point
from the half to top to a 50m point
I want to use UFER ground. If read a lot of articles found in the forum and the internet
but no one tells about how many metall grid you should put in a tower base.
Does for example a hole 1m (3ft) diameter, 2m deep (7ft) filled with concred and steel meshes to the job?
Are there any good sites with calculations? I have nothing found.
Thanks a lot for any info
Der GMX SmartSurfer hilft bis zu 70% Ihrer Onlinekosten zu sparen!
Ideal für Modem und ISDN: http://www.gmx.net/de/go/smartsurfer
More information about the TowerTalk