[TowerTalk] Help with Rotor Wires ID

[Gedas]

I am trying to make operational an antenna rotated by a HAM-IV rotor.  It's a long story but I have lost my documentation telling me which wires went to which terminal up there.  I have not sat down with the schematic in front of me to determine if everything can be deduced from ohm meter measurements on the ground.  I was using 8 conductor cable, all the same gauge.  Two questions:  1. can all the wire placements be determined via ohm meter accurately? and 2. does someone have a link or documentation for the procedure and expected values to do so.  Maybe it's a lot easier than I am thinking and should just go find the schematics.
73,
Gedas

Image Gallery http://gedas.cc
Web Site        http://w8bya.com