[TowerTalk] 6 meter yagi by DX Engineering

[Dino Darling]

Actually, the current "DX Engineering" folks bought the company from the
Oregon folks.  They may be able to help you.  I have heard rumor (first
hand) that they may come out with antennas again...specifically their
log periodic.

You have probably already contacted them.  If this is the case, scan the
manual and maybe someone can plug it into a modeling program for you.

Dino  -  K6RIX
dino at k6rix.com


> -------- Original Message --------
> Subject: [TowerTalk] 6 meter yagi by DX Engineering
> From: "Kinney John-r17512" <J.Kinney at freescale.com>
> Date: Mon, April 02, 2007 9:28 am
> To: <towertalk at contesting.com>
>
> I have a query for the group,
>
> I have a 6 meter antenna made by DX Engineering.  It is a 6DX8, 8
> element yagi on a 35+ foot boom.  The problem is, I have two instruction
> manuals with two sets of dimensions.  One manual has a date on the
> drawing of 11 Jan 1990, the other is not dated.  I sent an email to Dick
> Ewing, KO7N and Bill Sattler, N0XX via their addresses on QRZ, but both
> bounced as non-deliverable.  I also tried the phone number on the
> manual, but it has been disconnected.  As most of you are aware, the DX
> Engineering I am referring to is not the same DX Engineering that exists
> today in Ohio.  The company "DX Engineering" that made this antenna was
> located in Oregon.  I would like to know if anyone has one of these
> antennas and/or any information on getting in touch with either of these
> gentlemen?
>
> John Kinney
> KA7CVJ
> Tempe, Arizona
> 480-413-4290
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk