[TowerTalk] radial connections

[Larry DiGioia N8KU]

The inv-L consists of a Budwig connector, attached to a DX-engineering 
radial plate, which is jumpered over to a ground rod. All radials (both 
old and new) are #12 THHN. The old ones on the HyTower are sunk into the 
ground long ago, and the new ones on the inv-L are still on the ground 
for now.

Dan Hearn wrote:
> Larry, what is the shield of your coax connected to? A ground rod at the
> vertical base?. Are the radials bare or insulated wire? 73, Dan, N5AR
>
> -----Original Message-----
> From: towertalk-bounces at contesting.com
> [mailto:towertalk-bounces at contesting.com]On Behalf Of Larry DiGioia N8KU
> Sent: Sunday, December 02, 2007 7:51 AM
> To: towertalk at contesting.com
> Subject: [TowerTalk] radial connections
>
>
>
> I just got done installing a new inv-L for 160, right next to my
> existing Hy-Tower, which has 77 radials.
>
> I managed to get 4 new radials for 160 run before the wx turned bad, and
> I ran a single connecting wire between the two bases. Eventually, I will
> end up with two radial systems crossing over/intersecting each other.
>
> The antenna works fine, I got a GM last night on the first call with 100W.
>
> My question is, for now, if there are lots of radials underneath a
> vertical, BUT NOT CONNECTED TO IT, do they do anything?
>
> --
> Larry  N8KU
>
>  l o n g w i r e . c o m
>  HF - DX - CW - Digital
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
>
>   

-- 
Larry  N8KU

 l o n g w i r e . c o m
 HF - DX - CW - Digital