[TowerTalk] beam slippage

[john at kk9a.com]

The subject line says that the beam is slipping on the mast and not in the 
rotator.  If you install the Yaseu DXA1000 per the instructions, it will not 
slip without breaking something.  I am not familiar with SteppIR's mounting 
brackets, however most antennas are mounted with U-Bolts around a mast.  Are 
you using the correct size mast and of sufficient strength to not collapse 
when tightening?  Where the mounting bolts tight when you installed the 
antenna?.  The element SteppIR is not a big antenna and slipping should not 
be a problem, especially in only 30MPH winds.

John KK9A




To: "Brad Pioveson W9FX" <w9fx at verizon.net>,TowerTalk 
<towertalk at contesting.com>
Subject: Re: [TowerTalk] beam slippage
From: "bill rubin" <brubin2010 at gmail.com>
Date: Tue, 2 Oct 2007 15:12:41 -0500
List-post: <mailto:towertalk at contesting.com>

The rotor is a yeasu dxa1000 so a realignment is not an option. Also I have
a 2m ssb above it so it would be nice to have both pointing same direction.
Either way, I will have to move the beam, but need to prevent it from
happening again.

Some are suggesting another clamp brand Tennadyne Slipp-Nott.  But did not
know if putting a bolt through the mount plat and mast would help or be a
bad idea.



On 10/2/07, Brad Pioveson W9FX <w9fx at verizon.net> wrote:
>
> The answer - or, answers, as there can be more than one - depend on what
> kind of rotor you have, Bill, and, what kind of hardware you're using to
> secure the mast in that rotor's mast socket.
>
> 73, Brad, W9FX
>
>
> ----- Original Message -----
> From: "bill rubin" <brubin2010 at gmail.com>
> To: "TowerTalk" <towertalk at contesting.com>
> Sent: Tuesday, October 02, 2007 2:12 PM
> Subject: [TowerTalk] beam slippage
>
>
> > Well I just mounted steppir 3 ele on the new tower and the next day we
> had
> > a
> > storm with 30+ mph winds.  The  beam is now of by aprox. 10
> degrees.  What
> > can I do to fix this ?
> >
> > 73's Bill