[TowerTalk] Swedging

[dan]

Reduction in size of aluminum tube end so smaller size will fit swedging. I 
want to reduce each taper by 1/8 inch 2 to 1 /7/8  1 /7/8 1 5/8 etc

Dan NN7J
----- Original Message ----- 
From: "dan" <longterm at chatusa.com>
To: <towertalk at contesting.com>
Sent: Sunday, October 28, 2007 7:41 PM
Subject: [TowerTalk] Sweding


> Looking for ideas on swedging, have  hyd 200 ton press. Like to swed 2 
> inch to 1/2 inch Al tube.
>
> Dan NN7J
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>