[TowerTalk] Tailtwister Rotor wires

[Bob]

Alphabetical has always worked to me!

Bob W7KD


----- Original Message ----- 
From: "RICHARD SOLOMON" <w1ksz at q.com>
To: <towertalk at contesting.com>
Sent: Monday, August 04, 2008 7:07 PM
Subject: Re: [TowerTalk] Tailtwister Rotor wires


> One of the locals had a great scheme, once you connect the larger
> motor wires the rest follow the Resistor Color Code (B-B-R-O, etc).
>
> No need to write anything down.
>
> 73, Dick, W1KSZ
>
>
>
>> From: k5fnq at cox.net> To: towertalk at contesting.com> Date: Mon, 4 Aug 2008 
>> 20:46:39 -0500> Subject: [TowerTalk] Tailtwister Rotor wires> > OK, I 
>> admit to screwing up. but it was for a good cause.> Local was doing tower 
>> work and had rotor problems. I volunteered to come > home and get my TX2 
>> control box in case his was bad.> I wrote down the color code when I took 
>> off the wires and have now lost the > little piece of paper I used.> > I 
>> think I have it right as the manual has the color codes, it has just been 
>>  > up too long to be sure.> > I see in the manual a way to check 
>> resistance on the wires.> Is this the only way to try and figure out the 
>> wiring or do I have to get > someone up the tower to check?> Yeah it was 
>> a dumb move, but all for a good cause at the time.> Art K5FNQ> > 
>> _______________________________________________> > > > 
>> _______________________________________________> TowerTalk mailing list> 
>> TowerTalk at contesting.com> 
>> http://lists.contesting.com/mailman/listinfo/tow
> ertalk
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>