[TowerTalk] UT-8000 Cable Prep Tool

[Dave Harmon]

The UT-8000 doesn't work on LMR-400 but you can go here and look around.
http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=25

For those who are thinking about getting a UT-8000 for RG-213, RG-8, Davis
RF Bury-Flex and other .405 o/d coax.....the UT-8000 is definitely worth the
$39 from DX Engineering.
This thing gets it right every time and I prepped the first coax in less
than 30 seconds.
After that, it was a lot quicker and perfect too.

Never use a knife of any kind.....
Been there, done that...and it ain't worth a damn.

Regards

Dave Harmon
K6XYZ[at]sbcglobal[dot]net
Sperry, Ok.

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Larry Burke
Sent: Monday, March 10, 2008 10:45 PM
To: towertalk at contesting.com
Subject: [TowerTalk] UT-8000 Cable Prep Tool


Does the Cablematic UT-8000 cable prep tool work on LMR400 cable? It's
billed as working on RG-8/U and 213/U, but no mention of anything else. If
not, is there a similar tool out there for LMR400 that is reasonably priced?



Larry Burke K5RK
Brazoria County Texas


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk