[TowerTalk] House entrance ground for RF ground?

[Dick Green WC1M]

I think both Dave and Bob are correct. Best thing to do is install a proper
single-point ground (SPG) as close to the station as possible. This can
consist of one or more ground rods bonded together with low-impedance wire
or copper strap. The SPG should be bonded to the electric company ground, as
well as the  tower/antenna ground system. Your station connection should be
to the SPG. Ideally, the SPG should be bonded to a metal plate on the side
of the house where the cables from your antennas attach to lightning
suppressors before they enter the house.

73, Dick WC1M

 
> -----Original Message-----
> From: Bob Maser [mailto:bmaser at tampabay.rr.com]
> Sent: Sunday, October 05, 2008 5:18 PM
> To: k1ttt at arrl.net; 'TowerTalk'
> Subject: Re: [TowerTalk] House entrance ground for RF ground?
> 
> I don't think that using the electric company ground is a very good
> idea.
> It is usually just a single ground rod that they pound into the ground
> near
> the electric box.
> 
> Bob W6TR
> ----- Original Message -----
> From: "David Robbins K1TTT" <k1ttt at arrl.net>
> To: "'TowerTalk'" <towertalk at contesting.com>
> Sent: Sunday, October 05, 2008 5:12 PM
> Subject: Re: [TowerTalk] House entrance ground for RF ground?
> 
> 
> That is exactly the right thing to do.
> 
> David Robbins K1TTT
> e-mail: mailto:k1ttt at arrl.net
> web: http://www.k1ttt.net
> AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> 
> 
> > -----Original Message-----
> > From: Gary Slagel [mailto:gdslagel at yahoo.com]
> > Sent: Sunday, October 05, 2008 20:48
> > To: TowerTalk
> > Subject: [TowerTalk] House entrance ground for RF ground?
> >
> > Hi,
> >
> > My shack is on the first floor of the house and right above the
> electrical
> > service entrance in the basement. For my station RF and DC ground,
> I'm
> > thinking I'll run a 10' wire from the station down to the electrical
> > entrance ground wire which, of course, runs right out to ground rods
> > outside the house. Is there any problem with this or should I be
> running
> > to a separate ground rod?
> >
> > Thanks for any opinions!
> >
> > Gary Slagel/N0SXX
> > Hot Springs, SD
> > http://marina.fortunecity.com/sanpedro/351
> >
> >
> >
> > _______________________________________________
> >
> >
> >
> > _______________________________________________
> > TowerTalk mailing list
> > TowerTalk at contesting.com
> > http://lists.contesting.com/mailman/listinfo/towertalk
> 
> 
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>