[TowerTalk] Window feed throughs

[n8de at thepoint.net]

The problem in weathersealing this 'contraption' is NOT at the window  
opening, it's at the place where the two window sections overlap.    
Without adequate sealing there, the snow will blow right through that  
'crack'.  (Spoken from experience.)
Best method is to replace the movable section of window with a large  
Lexan sheet and seal it around every edge.  (been there, done that)
Don
N8DE

Quoting Andre Van Wyk KR5DX <kr5dx at yahoo.com>:

> Very neat!
>
> You could also use aluminum flat bar and barrel connectors and run a
> jumper from it to ground.
>
> 73
>
> nz4o at tampabay.rr.com wrote:
>> Tom I made my own out of a 6" wide oak board. Here are some pictures.
>>
>> http://www.kn4lf.com/serviceentrance2.jpg
>> http://www.kn4lf.com/serviceentrancein3.jpg
>>
>> 73 & GUD DX,
>> Thomas F. Giella, NZ4O
>> Lakeland, FL, USA
>> nz4o at tampabay.rr.com
>>
>> NZ4O Amateur & SWL Radio Autobiography: http://www.nz4o.com
>>
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>