[TowerTalk] Antenna Modeling needed 160 vertical

[Ed Stallman]

Hello Towertalkers

My plan is to construct a 160m vertical using 4 inch irrigation 
tubing 90 ft tall, with 4 top loading wires spaced 90 degree and 
sloping down at 45 degrees . My target freq is 1.830 but would like 
to make the top-loading a bit short so that the antenna was resonant 
about 2 MHz.  Then put a small (a few uH) loading coil at the base to 
bring the antenna to resonance at the desired frequency.  I am 
placing the antenna 300ft away from any other structure , hoping for 
no interaction . I'll start with 32 ground radials and add more 
later, not sure on the length ? 90ft or 130ft ?

two questions
how long will the top-loading wires be for resonant at about 2 MHz 
using # 14 copper insulated wire?
how long should I make the ground radials ?

Thanks Ed N5DG