[TowerTalk] HDX-89 rotator replacement - w/o tilting the tower over?
K7LXC at aol.com
K7LXC at aol.com
Thu Dec 30 06:20:36 PST 2010
In a message dated 12/29/2010 11:32:47 P.M. Pacific Standard Time,
towertalk-request at contesting.com writes:
> I have an US Tower HDX-89 tower, and I need to replace the Tailtwister
2
currently nestled in the top section below the thrust bearing. Is it
possible,
and what's the procedure, to remove and reinstall a rotor w/o tilting over
the
tower? I will have removed the antennas and mast, but don't how far the
tower
must be extended to access the rotator plate.
Hiya, Brian --
You don't need to remove the antennas and mast. Run the tower up far
enough so that the rotator is accessible, block the bottom of sections with
2x4's or pipes to prevent downward tower movement and go on up. You can use
a comealong to lift the mast up enough to clear the rotator or a pry bar
of some sort. You can get the mast up enough to do the swap and then it's
pretty straightforward.
Cheers,
Steve K7LXC
TOWER TECH
Cell:206-890-4188
More information about the TowerTalk
mailing list