[TowerTalk] A3S tribander gone bad

[TexasRF at aol.com]

Measured where? At the feed point? At the end of XXft of ?? coax?
 
73/k5gw
 
 
 
In a message dated 11/15/2010 6:33:09 A.M. Central Standard Time,  
rob.katz at thelegacycenter.com writes:

I am  putting back up a Cushcraft A3S tribander after it was on the ground
for  several years.  I've cleaned it and rebuilt it, triple checking  the
dimensions.  Installed at 45 feet, I get the following MFJ 269B  readings 
for
best resonances: 10m - 26.6 MHz, SWR=1.8, R=38, X=33; 15m -  21.55 MHz,
SWR=4.3, R=8, X=21; 20m - 14.95 MHz, SWR=2.9, R=37,  X=73.

These resonances are very sharp, and clearly not right.  Any  ideas on how 
to
test this?  Is there a simple way to test each  trap?  While I didn't open 
up
each trap, I did soak them and  thoroughly rinse them to try to clean any 
any
stuff that might have been  inside.

Thanks and 73,
Rob, KA1ARB

-- 
Rob  Katz, Director
Legacy Center, Inc.
(919) 678-6000 x106   (919)  678-6015  fax
www.TheLegacyCenter.com


_______________________________________________



_______________________________________________
TowerTalk  mailing  list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk