[TowerTalk] Hy-Gain rotor controllers cabling

[Don Tucker]

Good move on their part to get rid of the strip. I modified all my T2X's and 
Ham-M's, but went to 8 pin trailer connectors which are designed for severe 
weather condx.

Don W7WLL
----- Original Message ----- 
From: "Barry Gross" <n1eu at yahoo.com>
To: <towertalk at contesting.com>
Sent: Tuesday, October 19, 2010 7:23 AM
Subject: Re: [TowerTalk] Hy-Gain rotor controllers cabling


I've received several private replies that indicate folks aren't aware that 
Hy-Gain was installing rear panel mount 8-pin Cinch Jones connectors in the 
later Hy-Gain Ham IV rotor controllers instead of 8-pin terminal strips.

I will proceed with the informed assumption that pin numbers 1-8 are 
identically connected.

Barry N1EU

--- On Tue, 10/19/10, Barry Gross <n1eu at yahoo.com> wrote:

> From: Barry Gross <n1eu at yahoo.com>
> Subject: Hy-Gain rotor controllers cabling
> To: towertalk at contesting.com
> Date: Tuesday, October 19, 2010, 7:30 AM
> Can anyone confirm that rotor cable
> connection pin numbering 1-8 of a T2X terminal block is
> identical to pin numbering 1-8 of a Ham IV cinch Jones
> connector?
>
> Tnx/73,
> Barry N1EU
>
>
>
>



_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk