[TowerTalk] Hy-Gain rotor controllers cabling

[Roger (K8RI)]

On 10/19/2010 10:23 AM, Barry Gross wrote:
> I've received several private replies that indicate folks aren't aware that Hy-Gain was installing rear panel mount 8-pin Cinch Jones connectors in the later Hy-Gain Ham IV rotor controllers instead of 8-pin terminal strips.

"Some" rotators are getting the Cinch Jones.  The tail twister is 
getting the round connector for which I've forgotten the name.
Any time I rebuild one, it's getting that new pig tail with the round 
connector.

73

Roger (K8RI)
> I will proceed with the informed assumption that pin numbers 1-8 are identically connected.
>
> Barry N1EU
>
> --- On Tue, 10/19/10, Barry Gross<n1eu at yahoo.com>  wrote:
>
>> From: Barry Gross<n1eu at yahoo.com>
>> Subject: Hy-Gain rotor controllers cabling
>> To: towertalk at contesting.com
>> Date: Tuesday, October 19, 2010, 7:30 AM
>> Can anyone confirm that rotor cable
>> connection pin numbering 1-8 of a T2X terminal block is
>> identical to pin numbering 1-8 of a Ham IV cinch Jones
>> connector?
>>
>> Tnx/73,
>> Barry N1EU
>>
>>
>>
>>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>