[TowerTalk] Modeling over ground was: Re: H frame for 10 or 15m

Pete Smith n4zr at contesting.com
Tue Aug 16 12:34:53 PDT 2011


Jim, I always test results in HFTA, and compare the theoretical patterns 
over flat ground with my actuals.  I also use MultiNEC for modeling 
(wish I had the NEC4 engine, but hey...), and where appropriate I apply 
the notches and reinforcements from HFTA to the MultiNEC patterns.  My 
terrain is relatively flat, though, so I feel comfortable not carrying 
my terrain profiles out over 3000 meters.

73, Pete N4ZR

The World Contest Station Database, updated daily at www.conteststations.com
The Reverse Beacon Network at http://reversebeacon.net, blog at reversebeacon.blogspot.com,
spots at telnet.reversebeacon.net, port 7000



On 8/16/2011 11:55 AM, Jim Brown wrote:
> On 8/16/2011 7:35 AM, Pete Smith wrote:
>> For example, if I model against
>> ground, and put the antennas at heights of 50 and 100 feet, my 14 MHz
>> vertical pattern is very broad and clean, with no second lobe below 35
>> degrees or so.
> Don't forget that all of this can be QUITE dependent on the terrain in
> the region up to at least five miles from your antenna.  N6BV's HFTA
> software allows us to model this, using data readily available on the
> internet.  That software comes with the ARRL Antenna Book, and is worth
> the cost of the book.
>
> 73, Jim Brown K9YC
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>


More information about the TowerTalk mailing list