[TowerTalk] Tower Legs

[Gene Smar]

Warren et al:

     I bought s few sample piees of stainless sheet from Online Metals 
http://www.onlinemetals.com/merchant.cfm?id=284&step=2 .  I used one of the 
sheets to shim out the space between my mast and the bearing at the top of 
the tower.

73 es Happy Holidays de
Gene Smar  AD3F


----- Original Message ----- 
From: "Warrenwolff" <warrenwolff at aol.com>
To: <towertalk at contesting.com>
Sent: Thursday, December 22, 2011 12:40 PM
Subject: [TowerTalk] Tower Legs


> Greetings:
>
> I note the comment about CadWelding to a tower
> leg.  I have seen posts here (where else?) on how
> to do it and then, just "don't do it".
>
> The installer I am using wants to exothermically
> attach my #2 copper to the legs of an AN-HD60
> tower, whose legs are definitely not thin.
>
> This was in response to my failed attempts to locate
> any "stainless shims" for clamping the #2 to the
> legs.
>
> Comments, please.
>
> Warren; W7WY
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk