[TowerTalk] Tower Legs

[N2TK, Tony]

HD also has a ground clamp that is lead based. So, no interaction with the
tower leg.
73,
N2TK, Tony 

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Steve Jones
Sent: Thursday, December 22, 2011 1:25 PM
To: towertalk at contesting.com; Warrenwolff
Subject: Re: [TowerTalk] Tower Legs

Warren-

The engineer at US Tower told me a Home Depot bronze ground clamp on my
galvanized HDX-589 tower would be fine.  The clamp wraps around a tower
brace and the #2 copper wire goes into a hole with a lock nut on the back of
the clamp.  Copper and zinc never touch each other.

73,
Steve
N6SJ

----- Original Message -----
From: "Warrenwolff" <warrenwolff at aol.com>
To: <towertalk at contesting.com>
Sent: Thursday, December 22, 2011 9:40 AM
Subject: [TowerTalk] Tower Legs


> Greetings:
>
> I note the comment about CadWelding to a tower
> leg.  I have seen posts here (where else?) on how
> to do it and then, just "don't do it".
>
> The installer I am using wants to exothermically
> attach my #2 copper to the legs of an AN-HD60
> tower, whose legs are definitely not thin.
>
> This was in response to my failed attempts to locate
> any "stainless shims" for clamping the #2 to the
> legs.
>
> Comments, please.
>
> Warren; W7WY
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk